Bent Axis Pumps |
(english) In this pump, the pistons are at an angle to the drive shaft and Thrust Plate. The piston block shaft is connected to the drive shaft by a universal joint, not shown. The drive shaft, thrust plate, piston block shaft, and piston block all revolve. The connecting rods are attached to the thrust plate and revolve with it, unlike the swash plate pump where the piston rods slide past a stationary swash plate. The outlet ports are semi-circular holes in the Valve Plate, shown on the far right of the animation on edge and in a head-on view below, right. As the pump revolves, half the pistons suck in fluid as they pass over the intake port. The other pistons discharge their fluid through the outlet port. This pump should be compared to the radial piston pump, swash plate pump, and wobble pump. |
Bentonite |
(english) A colloidal clay derived from volcanic ash and employed as a binder in connection with synthetic sands, or added to ordinary natural (clay-bonded) sands where extra strength is required. |
Beryllium Copper |
(english) An alloy of copper and 2-3% beryllium with optionally fractional percentages of nickel or cobalt. Alloys of this series show remarkable age-hardening properties and an ultimate hardness of about 400 Brinell (Rockwell C43). Because of such hardness and good electrical conductivity, beryllium-copper is used in electrical switches, springs, etc. |
Bessemer Process |
(english) A process for making steel by blowing air through molten pig iron contained in a refractory lined vessel so that the impurities are thus removed by oxidation. |
BETA RATIO (#) |
(english) The amount, expressed as a ratio, of particles in a fluid stream upstream of a filter, after the fluid posses through a filter, divided by the amount of particles downstream, for a particular size particle. |
Bevel |
(english) Angle formed between the prepared edge of the end of tube and a plane perpendicular to the surface. Standard pipe bevel is 30 degrees. |
Big Winch |
(english) The tool used to spot (or position) the rail cars for unloading. It is located on the north end of the unloading area. |
Billet |
(english) (1) A semi-finished section hot rolled from a metal ingot, with a rectangular cross section usually ranging from 16 to 36 in., the width being less than twice the thickness. Where the cross section exceeds 36 in., the term “bloom” is properly but not universally used. Sizes smaller than 16 in. are usually termed “bars”; a solid semi-finished round or square product which has been hot worked by forging, rolling, or extrusion. (2) A semi-finished, cogged, hot rolled or continuous-cast metal product of uniform section, usually rectangular with radiused corners. Billets are relatively larger than bars. |
Billet 2 |
(english) A solid semi-finished round or square product that has been hot worked by forging, rolling, or extrusion. An iron or steel billet has a minimum width or thickness of 1 1/2 in. and the cross-sectional area varies from 2 1/4 to 36 sq. in. For nonferrous metals, it may also be a casting suitable for finished or semi-finished rolling or for extrusion. |
Billet container |
(english) The part of the extrusion press into which the billet to be extruded is placed. |