| Holding Period Period | (Concrete Engineering) In the manufacture of concrete products, the period between completion of casting and the introduction of additional heat or the steam curing period |
| HRM High Reactivity Metakaolin. | (Concrete Engineering) Refined form of an ASTM C618, Class N (natural) pozzolan. A high performance, mineral admixture, similar in performance to silica fume, additionally comparable in cost. Pure white powdered in form will, not effect the natural color or darken concrete as silica fume does. Suitable for high-performance color matching in architectural concrete. Dosage at 5% to 10%, of cement by weight. No bleed water, better finishability, more creamy, cleanup is easier with slightly higher 28 day strengths and 25% - 35% less plasticizer is required than silica fume. |
| Hydrogenesis | (Concrete Engineering) Another term for condensation. The term is especially applied to base and soil substrates under highway pavements. where the barometric pump causes the inhalation of humid air, which then condenses in those structures, causing an ever increasing moisture content and sometimes instability. |
| Impermeable | (Concrete Engineering) The ability of a material or product to reduce or eliminate gaseous transmissions through it's mass; measured as the rate of Water Vapor Transmission (WVT). Note: Not all materials that are waterproof are vaporproof; all materials that are vaporproof are inherently waterproof. |
| Keene's Cement | (Concrete Engineering) A finely ground high density plaster composed of anhydrous, (calcined or "dead burned") gypsum, the set of which is accelerated by the addition of other materials. |
| Kelly Ball | (Concrete Engineering) A device for determining the consistency of fresh concrete. It is sometimes used as an alternative to the slump test. |
| Mass Curing | (Concrete Engineering) Adiabatic curing, using sealed containers. |
| Moist Room | (Concrete Engineering) A room used for storing and curing cementitious test specimens. The atmosphere of this room is maintained at a temperature of 73.4 3.0'F or 23.0*1.7'0 and relative humidity of at least 98 percent. These facilities must be adequate to continually maintain free moisture on the exteriors of test specimens. |
| Neat Cement-Paste | (Concrete Engineering) A mixture of water and hydraulic cement, both before and after setting and hardening. |
| Ottawa Sand | (Concrete Engineering) A sand used as a standard in testing hydraulic cements by means of mortar test specimens. Sand is produced by processing silica rock particles obtained by hydraulic mining of the orthoquartzite situated in open-pit deposits near Ottawa, Illinois; naturally rounded grains of nearly pure quartz. |