| Brinell Hardness | (english) The hardness of a metal or part, as represented by the number obtained from the ratio between the load applied on the spherical area of the impression made by a steel ball forced into the surface of the material tested. |
| Brinell Hardness Number | (english) The value of hardness of a metal on an arbitrary scale representing kg/mm2, determined by measuring the diameter of the impression made by a ball of given diameter applied under a known load. Values are expressed in Brinell Hardness Numbers, BHN |
| Brinell Hardness Test | (english) A common standard method of measuring the hardness of materials. The smooth surface of the metal is subjected to indentation by a hardened steel ball under pressure. The diameter of the indentation, in the material surface, is then measured by a microscope and the hardness value is read from a chart or determined by a prescribed formula. |
| Brinell Hardness Testing | (english) Method of determining the hardness of materials; involves impressing a hardened ball of specified diameter into the material surface at a known pressure (10-mm ball, 500-kg load for aluminum alloys). The Brinell hardness number results from calculations involving the load and the spherical area of the ball impression. Direct-reading testing are generally used for routine inspection of forgings, and as a heat treat control function. |
| Brittle Fracture | (english) Fracture with little or no plastic deformation. |
| Brittle Fracture 2 | (english) Fracture preceded by little or negligible plastic deformation. |
| Brittleness | (english) The tendency of a metal or material to fracture without undergoing appreciable plastic deformation. |
| Broaching | (english) Smoothing machined holes or outside surfaces of castings by drawing pushing on or more broaches (special cutting tools) through the roughed out hole. |
| Bronze | (english) An alloy containing 90% copper and 10% tin. Used for screws, wire, hardware, wear plates, bushings and springs; it is somewhat stronger than copper and brass and has equal or better ductility. |
| Brown Sharp Gages | (english) A standard series of sizes refered to by numbers, in which the diameter of wire or thickness of sheet metal is generally produced and which is used in the manufacture of brass, bronze, copper, copper-base alloys and aluminum. These gage numbers have a definite relationship to each other. In this system, the decimal thickness is reduced by 50% every six gage numbers- while temper is expressed by the number of B&S gage numbers as cold reduced in thickness from previous annealing. For each B&S gage number in thickness reduction, where is assigned a hardness value of 1/4 hard. |